DISPENSER GUN FOR CFS + 300 ML and 600ML FOILS [BOX OF 1]

Description

Professional dispensing system for bonded anchors in 300 ml foil loads

Drill hole to the required diameter and depth for threaded rods size being used.
Clean the hole thoroughly with brush and hand pump at least four times before installation.
Insert foil into gun and attach nozzle.
Dispense to waste until even colour is obtained.
Insert the mixer nozzle to the bottom of the drill hole and inject resin, slowly withdrawing the nozzle as the hole is filled to 70% of its depth.
Immediately insert the rebar, slowly and with slight twisting motion. Remove any excess resin around the hole before it sets and leave it undisturbed until the curing time elapses.
Attach fixture and tighten the nut to the required torque.